Rapid Mix Tube, Fall 2009

Karen Alison Swetland, Patience Ruijia Li

Abstract

During the fall 2009 semester, the main focus of the Rapid Mix Tube subteam was the development and design of a rapid mix tube system to provide adequate large and small-scale mixing of alum with the raw water source entering the plant. The system developed in the fall 2009 semester is designed for the Agalteca plant, but the ultimate design can be modified to fit into future AguaClara plants and even fit into existing plants to improve rapid mix . The design of the system evolved multiple times throughout the semester, and the current system was developed to improve upon the main problem of those initial designs: access to the small scale rapid mix orifice to clean it in case of clogging. The design of the tube was thus tailored to fix this problem, and a MathCAD file calculating orifice sizes and head loss through the system was developed. A built prototype model of the rapid mix tube was also constructed to provide a model for the construction of the rapid mix tube system, and a series of experiments (to be run using FReTA) was also designed to test the effect of the rapid mix tube system on the effluent water turbidity and to determine the need for the rapid mix tube system.

Plate Settler Spacing - Experiments with Velocity Gradients, Fall 2009

Alexander Campbell Duncan, Rachel Beth Philipson

Abstract:

The Plate Settler Spacing team is currently investigating the Floc Roll-Up Phenomenon in the tube settler. By developing a velocity gradient model, we hope to both analytically and experimentally determine the critical velocity floc particles experience when they begin to roll up the settler tube and into the effluent rather than settling back down the tube and into the floc blanket. The critical velocity is determined using a force balance for a floc particle. In addition to determining this critical velocity, we hope to understand how properties of the flocs themselves affect floc roll-up.

Plate Settler Spacing - Experiments with Saturated Water, Fall 2009

Christine Lauren Catudal, Matthew William Hurst

This experiment explored the impact of water supersaturated with respect to atmospheric pressure on floc blanket formation and performance. This experiment involved collaboration with the Floating Floc Research Team, who supplied the saturated water that served as the influent water to the process.

Computational Fluid Dynamics Flocculation Tank Simulation, Fall 2009

Abstract:

Computational Fluid Dynamics (CFD) is a tool used by AguaClara to obtain a description of the flow through a portion of the plant where particle formation and growth (flocculation) occurs. This part of the plant is referred to as the flocculator. In this section, dirty (turbid) water flows through a series of baffles that enhances turbulent mixing. Essentially, for particles (flocs) to grow and eventually settle out in the sedimentation tank, they first must collide. By increasing the level of turbulence, the flocculator is increasing the collision potential of flocs. However, if there is too much turbulence, the flocs will break up and not settle out. By running CFD simulations of the flocculator, AguaClara can analyze the parameters important to flocculation and use the resulting data when making design decisions.